 |
| broken stem from hydraulic valve assembly - most common problem inside the control boxes |
 |
| baseplates completely rusted off so the support boards detatch |
 |
| hydraulic pump went out on 8/30/19 |
 |
| bypassing the existing hydraulic line from the valve to the inlet to the control box (#16) |
 |
| debris caught by filter by ball valve outside of the control box |
 |
| upper transfer pump seal broken causing one of the pumps to leak water - towel + duct tape |
 |
| fitting that connects the hydraulic line leading to the control box to the ball valve and hydraulic pipe |
 |
| clogged screen on the control box side of the ball valve - contaminated hydraulic line |
 |
| leaking control box |
 |
| picture of the valve boxes outside of the control box |
 |
| leaking stem - control box |
 |
| 8/26/19 - #2 green - topdress gate 4 gear 1, 3/8" tine on 2.0" spacing, depth H |
 |
| 8/26/19 - alternate angle |
 |
| 8/26/19 - #4 green |
 |
| 8/26/19 - double verticutting plugs and sand at 1/8" - #2 green - 1st pass |
 |
| 8/26/19 - after 2nd verticut pass |
 |
| 8/28/19 - #3 green - hydraulic leak from Salsco Roller - after charcoal application and flush |
 |
| 8/30/19 - #3 green - after hydraulic leak |
 |
| 9/5/19 - #3 green after hydraulic leak |
 |
| 9/5/19 - #3 green after hydraulic leak |
 |
| 9/5/19 - closeup of hydraulic leak 8 days afterwards |
 |
| 9/3/19 - closeup of greens 8 days after aerification |
 |
| 9/3/19 - sideview of greens 8 days after aerification |
 |
| 9/5/19 - closeup of greens 10 days after aerification |
 |
| 9/5/19 - #9 fairway |
 |
| 8/27/19 - #12 gold tee aerification - 5/8" core on 2.0" spacing, depth H |
No comments:
Post a Comment